Partner P Formula 55 - 14 40cc Manual do Utilizador descarregar pdf (Página 8)

Tensioning Lever

LOOSEN

5. While lifting tip of guide bar, turn adjust-

ment knob handle clockwise to clamp

bar. Tighten until bar is clamped secure-

ly. Hand tighten securely; do not use

tools to tighten!

6. Using chain adjustment tool (bar tool),

roll chain around guide bar to ensure all

links are in bar groove.

7. Return adjustment knob handle to original

position. Ensure teeth of adjustment knob

handle are engaged with notches in the

chain brake and adjustment knob handle

is laying flat.

WARNING: If the saw is operated

with a loose chain, the chain could jump off

the guide bar and result in serious injury

WARNING: Muffler is very hot during

and after use. Do not touch the muffler or al-

low combustible material such as dry grass

or fuel to do so.

OPERATING YOUR UNIT

BEFORE STARTING ENGINE

WARNING: Be sure to read the fuel

information in the safety rules before you be-

gin. If you do not understand the safety rules,

do not attempt to fuel your unit. Contact an

authorized service dealer.

BAR AND CHAIN LUB RICATION

The bar and chain require continuous lubri-

cation. Lubrication is provided by the auto-

matic oiler system when the oil tank is kept

filled. Lack of oil will quickly ruin the bar and

chain. Too little oil will cause overheating

shown by smoke coming from the chain and/

or discoloration of the bar.

Only use Bar and Chain Oil for bar and chain

lubrication.

Oil Cap

Fuel mix cap

FUELING ENGINE

WARNING: Remove fuel cap slowly

when refueling.

This engine is certified to operate on unleaded

gasoline. Before operation, gasoline must be

mixed with a good quality 2-cycle air-cooled

engine oil designed to be mixed at a ratio of

40:1. A 40:1 ratio is obtained by mixing 0,125

liter of oil with 5 liters of unleaded gasoline. DO

NOT USE automotive or boat oil. These oils

will cause engine damage. When mixing fuel

follow the instructions printed on the container.

Always read and follow the safety rules relating

to fuel before fueling your unit.

IMPORTANT

Experience indicates that alcohol blended

fuels (called gasohol or using ethanol or

methanol) can attract moisture which leads

to separation and formation of acids during

storage. Acidic gas can damagethe fuel sys-

tem of an engine while in storage. To avoid

engine problems, empty the fuel system be-

fore storage for 30 days or longer. Drain the

gas tank, start the engine and let it run until

the fuel lines and carburetor are empty. Use

fresh fuel next season. Never use engine or

carburetor cleaner products in the fuel tank

or permanent damage may occur.

CHAIN BRAKE

Ensure chain brake is disengaged by pulling

the front hand guard back toward the front han-

dle as far as possible. The chain brake must

be disengaged before cutting with the saw.

WARNING: The chain must not

move when the engine runs at idle speed. If

the chain moves at idle speed refer to CAR-

BURETOR ADJUSTMENT within this

manual. Avoid contact with the muffler. A hot

muffler can cause serious burns.

To stop the engine, move the ON/STOP

switch to the STOP position.

To start the engine, hold the saw firmly on

the ground as illustrated below. Make sure

the chain is free to turn without contacting

any object.

Hold saw firmly while pulling starter rope.

Use only 40 --- 45 cm o

rope per pull.

IMPORTANT POINTS TO REMEMBER

When pulling the starter rope, do not use the full

extent of the rope as this can cause the rope to

break. Do not let starter rope snap back. Hold

the handle and let the rope rewind slowly.

For cold weather starting, start the unit at full

choke; allow the engine to warm up before

squeezing the throttle trigger.

NOTE: Do not cut material with the choke/

fast idle lever at the FULL CHOKE position.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Comentários a estes Manuais

Sem comentários

Partner P Formula 55 - 14 40cc Manual do Utilizador Página 8

Comentários a estes Manuais

Manuais e produtos relacionados com Motosserras elétricas Partner P Formula 55 - 14 40cc